4
Additional Requirements
The following items are not included, but are necessary for
the proper assembly of your heater. Do NOT attempt to
assemble without proper tools.
Philips screwdriver w/ medium blade.
Adjustable opening wrench.
Leak Detection Solution(Instructions on how to make
solution are included in step )
Note: You must follow all steps to properly assemble
heater.
...
WARNING
California Proposition 65
Combustion by products produced when using
this product contain chemicals known to the state
of California to cause cancer, birth defects, and
other reproductive harm.
Step 1 – Attach Support Brackets to Base
.
Attach three Support Brackets loosely to Base with
three medium bolts downward through Support
Brackets into the Base.
3 Req’d Medium Bolts
Installation process
Reverse the base, fix the
ground fixer to the base with
bolts and washers like picture
shows.
To protect heater from strong wind, anchor
the base securely to the ground
with screws.
Firm the ground fixer with nuts.
Fix another two ground fixer with bolts and nuts,
and reverse the base.
Hardware
Picture
Qty
Description
Used in
Step(s)
6
3
1
Large Bolt
2
3
Medium Bolt
1
4
Small Bolt
Ground Fixer
9
Small Screw
6
5
9
Large Flat
Washer
4 / 7
9
Small Flat
Washer
6
6
Small Flange
Nut
2
9
Cap Nut
6
3
Wing Nut
7
3
Reflector Stud
4
1
Wrench
1 / 2 / 5 / 6
6
Small Bolt
1
6
6
Small Flat
Washer
1
1
Nut
