14
OPERATION INSTRUCTIONS
If you experience any ignition problem please consult “Troubleshooting” on page 18.
Caution:
Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of
oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately
30 minutes. The heater should NOT produce thick black smoke.
Note:
The burner may be noisy when initially turned on.
Turn the knob to the level of heat desired.
in.
in.
in.
in.
in.
in.
Normal
Abnormal
Lighting:
1. Turn on the valve on the gas cylinder.
2. Press and turn the control knob to HIGH (maximum) position (counter-clockwise 90º). (Figure 1)
3. Holding down the control knob, press the igniter button several times until the main flame is ignited.
Release the control knob 10 seconds after the ignition.
4. Turn the control knob to LOW (minimum) and leave it there for 5 minutes or more before turning the
knob to the desired temperature setting. (Figure 2)
5. If the burner flame goes out, turn off the heater and wait at least 5 minutes or more to let the gas
dissipate before re-lighting to avoid gas explosion.
Repeat steps 2 to 4.
Figure 1
Figure 2
