Page 7
Attachment
Before Attaching the Machine
Before attachment, ALWAYS ensure the following:
- The carrying vehicle has sufficient capacity for the fully laden unit (Machine weight circa 90kg + Max feed capacity
(varies with feed used, this must be checked!) = total laden weight
- All safety guards & decals are in good working order and correctly fitted
- Electrical connections are free of dirt and moisture
Attaching the Machine
NOTE: This machine is designed to attach to the carrying vehicle using 4 x ratchet straps. Never use less than 4
straps to secure the load as movement may result!
1.
Remove tailgate from carrying vehicle.
2.
Load MF350 into bed using forklift slots or
suitable lifting strops rated to carry plated
unladen weight. If fitting for the first time
and the hopper has been shipped ‘upside
down’ then it can be carefully rolled into
the pickup bed by 2 people, as shown
below. Ensure that the control box and
cabling do not get trapped or damaged
during this procedure!
