C10325
v1.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~24S LiPo/LiFe battery
1~25Amps 1500W max.
www.chargery.com
page
6
total
16
1.
Connect C10325 to AC 110 / 220V outlet by the special heavy power cable, if use other brand cable,
please note the wire AWG must be AWG14 at least.
2.
Connect battery to charger.
3.
Connect Chargery BMS24T to charger if possible.
4.
2 seconds later, the idle interface is displayed; the charger is ready to charge. Actual output voltage,
current and internal temperature is also displayed, but C10325 is at idle mode (no output) to save
power consumption.
5.
Press
knob
shortly can choose Battery type; press again on Battery
type such as LiPo can enter into LiPo charge setup interface. Here,
you can setup cell count, charge current, charge terminal current,
and charge terminal voltage per cell, and then press
knob
for 3
seconds start charging.
Stop charging, the battery voltage will goes down, if need
maintain battery voltage, please setup the
Restart Charge
YES,
the charger will continue to charge when battery voltage goes
down to 5% of total battery voltage.
If set up to
YES
, the charger display KEEP after charge finished.
If set up to
NO
, the charger display DONE after charge finished.
