LT-CMPH-85
Page 2 of 4
Figure 2
Dimensions (in inches)
Part Number
Width
(W)
Depth
(D)
Height Overall
(H1)
Height Ground Line
(H2)
Weight
CMPH-8500 Series
39
”
28
”
56
”
46
”
96 lbs.
Table 1
Exterior Dimensions (in inches)
3.
INSTALLATION
3.1
Inspecting the Product
The enclosure is typically shipped upright on a skid. Unpack the unit, remove and dispose of the packaging material.
-INSPECTION NOTE-
Visually inspect the unit for damages prior to installation. If the enclosure was damaged in transit, immediately report the extent of the
damage to the transportation company.
3.2
Following and Using Safety Precautions
Read the following site and safety tips, cautions and warnings, then proceed with the paragraphs that follow.
For installation, follow all National Electrical Codes (NEC) ANSI/NFPA 70, local, environmental, workplace, and company
codes, safety procedures, and practices.
Read all instructions, warnings and cautions on the equipment and in the documentation shipped with the product.
Always connect ground connections first.
In windy conditions, be sure to cautiously remove the domes as they may be caught by the wind, causing physical injury to user
or adjacent equipment.
3.3
Obtaining Tools and Equipment
Obtain the following recommended or needed items for installing the enclosure for in-ground mounting.
Sufficient length of cables
Cable preparation tools
Wire strippers and connector installation tools
Protective and/or insulated work gloves
Safety glasses
Tape measure
