24
•
Press the
button on the remote, the
programming is finished when you hear 1
long beep from the appliance.
6b.38 Resetting the code for remote control is
necessary if the appliance operates wrongly
or the remote control does not operate
correctly.
•
Open the back cover of the remote control.
•
Press the Reset button on remote handset.
•
Follow the steps 6b.37
Resetting the Thermal Cut Out
6b.39 The appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance
overheats, e.g. when covered. If the heater stops operating while the
flame effect continues working normally, this indicates that the E.S.
Control is in operation. The E.S. Control can only be re-set after the
appliance has cooled down, and the appliance has been reset. Re-setting
of the E.S. Control proceeds is as follows:
6b.40 Switch off the appliance (Manual On/Off switch) and leave it off for
approximately 10-15 minutes.
6b.41 Remove any obstruction to the fan heater outlet or fan blades etc. Make
sure that the power supply is disconnected with the plug socket outlet
while doing this.
6b.42 Switch on the appliance and the E.S. Control will be re-set.
6b.43 Ensure that the appliance is functioning correctly. If the E.S. Control
operates again, the appliance should be checked by a competent
electrician.
Summary of Contents for 1500E
Page 2: ......
