16
LT8019
When unpacking the appliance please check the following items are included:
Fuel Bed
Owner Manual
Handset
Transformer
Top blanking plate
Front Cover grille
Flue spigots
SECTION SEVEN Regulations and Warnings (Installation Instructions)
•
This appliance must only be installed in Great Britain or Ireland.
•
The appliance is available in natural gas or LPG.
•
This appliance must be installed on a suitable outside wall.
•
No special ventilation bricks or vents are required into the room containing the appliance. In GB (Great
Britain)
It is the law that all gas appliances must be installed by a competent person; i.e. a GAS SAFE registered installer, in
accordance with the current Gas Safety (Installation and Use) Regulations (as amended), all relevant parts of the local
and national building regulations and all relevant recommendations of the current British Standards. Failure to do so
could lead to prosecution.
The following are the relevant codes of practice and British Standards: -
B.S. 5871 PART 2
B.S. 5440 PART 1
B.S. 6891
B.S. 1945
Note:- This appliance must be installed to current versions of the above standards and include any relevant
amendments.
The Building Regulations issued by The Department of the Environment.
The Building Standards (Scotland) (Consolidated) Regulations issued by The Scottish Development Office.
•
IN IE, (Ireland)
The appliance must be installed by a competent person and installed in accordance with the current edition of I.S.813
Domestic Gas Installation, the current building regulations, and the current ETCI rules for electrical installation, if
appropriate.
WARNINGS
•
As this appliance has components, which get very hot as with all such fires, it is recommended that a
fireguard should be used for the protection of children, the elderly, or the infirm. Fireguards should conform
to B.S.6539 (1984) (Fireguards for use with solid fuel appliances).
•
During initial use, an odour may be evident. This will soon disappear if the fire is run on its maximum setting
for a few hours.
•
Care must be taken to prevent any damage being caused to surrounding soft furnishing or decoration, e.g.
wall coverings may become discoloured if placed too close to the appliance.
Note:
A non-combustible hearth must be provided beneath the appliance and must project forwards by 100mm all
around the appliance base. The hearth must be level and have a minimum thickness of 50mm and must have a
clearly defined edge (change of level) to discourage placing of any combustible materials on or partially over it.
Minimum hearth size is 626mm wide x 456mm deep x 50mm high.
Summary of Contents for Edge 3s BF
