www.charltonandjenrick.co.uk
11
LT5878 (ISS 14)
GLASS CLEANING
From time to time it will be necessary to clean the glass panel of your 780 FL. We recommend you use a Ceramic hob
cleaner these are available for all leading super markets: -
i.e. ASDA, TESCO, SAINSBURY’S Etc.
Brands of hob cleaning we have tested and found suitable are -
HOB BRITE & VITRO CLEAN.
•
Ensure the fire as been turned OFF for at least four hours to ensure it is cool.
•
Remove the glass panel as described below.
•
Lay the glass panel down on a flat working surface on top of an old opened newspaper with the side to be
cleaned uppermost.
•
Follow the instructions on the Hob Cleaner Bottle.
•
On stubborn stains (where the appliance as been used for a long period without glass panel being cleaned),
use a new Brillo Pad well wetted with the Hob cleaner applied directly to it.
•
Ensure all the residues of the cleaner are removed with a damp cloth and the glass panel is completely dry
before fitting to the appliance.
•
Take care not to over-tighten the glass as this will result in the glass breaking. The glass is not covered by
warranty
Important:- The appliance must not be used if the glass panel is missing or damaged.
Note: - The glass may discolour quickly when first installed, and it should be cleaned. This is due to the burning off
process of the refractory fuel bed shapes.
SECTION FOUR Fuel Bed Cleaning and Layout (user instructions)
•
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
•
Use only the fuel bed components provided and no additional parts must added.
•
Incorrect positioning of the fuel bed components could result in the staining of the glass panel.
Important: -
Refer to the ‘Health & Safety Notice located on page 3 of this booklet
before cleaning or
replacing any refractory material.
•
The fuel bed components are delicate and they should be handled with great care.
•
The moulded shapes may be removed for cleaning. They can be brushed very gently with a soft brush to
remove dust or any deposits.
•
A vacuum cleaner may only be used after the loose components and moulded shapes have been removed.
CARE SHOULD BE TAKEN TO AVOID CONTACT WITH THE REFRACTORY LINING THIS IS A DELICATE SURFACE
AND SHOULD
NOT
BE WIPED OR RUBBED.
It is important that all the fuel bed moulded shapes are positioned as shown in these instructions.
Fitting the fire liners
Once the firebox is secured into position fit either the vermiculite or brick back liners supplied.
Position the 2- piece rear liner behind the 3 lugs located at the bottom rear of the firebox. The vermiculite liner has a
vertical joint and the brick back has a horizontal joint. Ensure these are aligned centrally.
Rest the side liner against the firebox on either left or right hand side. Push up the securing bracket to hold liner in
position. The vermiculite liners are reversible but the brick back liners will only fit one way.
