[8]
VARIO_WAir_Users_Manual_ver_301_GR_EN_1.docx
o
Automatic
(AUTO) Indicator AUTO is on. Controller activates smoothly the blower on low
protation speed (parameter
rL
) for temperatures greater than
tL
value and increases
proportionally up to the higher rotation speed limit of
rH
for temperature
tH
.
When any trouble on temperature sensor is detected controller message
Err
. When sensor error
occurred controller interrupts its normal blower operation in stand by (STBY) and automatic (AUTO)
modes. In manual mode (MAN) blower continues normally while display shows the message
Err
.
Parameters
Separate installer’s menu is provided. To enter installer’s menu continuously press the «
» key while
the device is being on “Off” state.
When entering the installer’s menu display shows the name of parameter instead of the current
temperature of the sensor. Navigate yourself among the parameters using the keys
«
» and «
». Then press Power to show the respective value of parameter which is blinking. Again
use arrows «
» and «
» keys to alter the value. To memorize the new value press Power key or leave
the device without pressing any key. The controller stores the new value and returns to the installer’s
menu.
Select “End” and then press Power to exit the menu.
