Right Support
Bracket
ASSEMBLY STEPS
Most
Charmglow
®
grill models will use
motor mount bracket
(Step 1 - Step 6),
if your grill is model 810-7400-S or
810-7500-S, use motor mount bracket
and skip to Step 7.
Step 1
Open grill hood and remove cooking
grills. Refer to your original grill
owner’s manual.
Step 2
Attach motor mount bracket 4B on
the left hand side of the grill using
two screws, washers and nuts.
Note: Motor mount bracket 4B may
be flipped to fit properly on
certain grills.
Step 3
Attach motor mount bracket 4A to
bracket 4B using one screw as
shown. Keep screw loose until height
adjustment has been set.
Step 4
If a notch on the right side of the grill
does not exist for your spit rod,
attach the spit rod support bracket to
the outside right hand side of the grill
using two screws, washers and nuts.
(Two sets of holes are provided
depending on your grill model.)
Step 5
Using a combination of sections,
securely assemble the spit rod to a
length that will rest on both the motor
mount bracket to the spit rod bracket.
Step 6
To set the proper height for your
motor mount bracket, place the motor
on the motor mount bracket, place the
spit rod in the motor and slide the
bracket adjustment up or down until
the spit rod is level. After adjustment
has been made, tighten motor mount
bracket 4A to bracket 4B with screw.
5
4
3
Motor Mount
Bracket 4A
Motor Mount
Bracket 4B
