1624VEB
– Optional Extension Bed
An Extension bed is available as an
optional extra. This can be fitted in either
of two positions enabling the distance
between centres to be increased by
575mm (22 ½”) or maximum bowl
diameter to 700mm (28”).
The bed is supplied with four M10 x
30mm Socket Head Mounting Bolts and
a tool rest extension (for use when bowl
turning).
To Extend the Lathe Bed for Between Centres Turning
Remove the Stop Pin from the tailstock
end of the lathe bed using a large flat
bladed screwdriver.
Attach the Extension Bed casting to end
of the main bed with the four M10 bolts,
flat and spring washers. Before finally
tightening the bolts ensure that the top
surfaces of the beds are exactly level &
aligned and that the tailstock can slide
smoothly over the joint.
Fit the Stop Pin to the extended bed
To Increase the Bowl Turning Capacity
Remove the Stop Pin from the tailstock
end of the lathe bed.
Remove the Tailstock and Tool Rest by
sliding them along the lathe bed.
Bolt the Extension Bed to the leg casting
using into the lower holes at the tailstock
end of the lathe.
Slide the Tool Rest assembly onto the
bed extension and fit the Stop Pin to
prevent it accidentally falling off.
Insert the Tool Rest Extension between
the Banjo and the Tool Rest Stem.
Release the Cam Lock and slide the
headstock until the casting is level with
the end of the bed. Lock the headstock
in place.
Summary of Contents for 1624V
Page 18: ...Charnwood 1624V Parts Drawing ...
