Replacing the Sanding Belt
Remove the bed support bolt using a
14mm spanner.
Remove the work table or tool rest if
fitted.
Loosen the two screws indicated and
slide off the drum dust cover.
Release the tension on the sanding belt
by pulling out the tension lever.
Loosen the two screws at the rear of the
belt which hold the bottom tray.
Slide and remove the tray.
It is now possible to remove the sanding
belt.
Locate the new belt over the two rollers.
Ensure that the arrow on the inside of the
belt corresponds to the direction marked
on the machine.
Replace the drum dust cover and bottom
tray, refitting/tightening all screws.
Re-tension the belt by closing the lever.
Track the belt.
Re-fit the bed support bolt and re-attach
the work/table or tool rest as required.
The life of the belts and discs can be greatly extended by regular cleaning with the BC01 Abrasive Disc &
Belt Cleaner which will remove any build-up of sawdust and resin.