Replacing the Sanding Belt
Remove the belt worktable.
Position the belt horizontally by
loosening the hex head screw with a
5mm hex key.
Loosen this screw
Remove this screw
Release the tension on the sanding
belt by pulling out the tension lever.
Slide off the dust collecting cover
Loosen the two screws at the rear of
the belt which hold the bottom tray.
Slide and remove the tray.
It is now possible to remove the
sanding belt.
Locate the new belt over the two
rollers. Ensure that the arrow on the
inside of the belt corresponds to the
direction marked on the machine.
Replace the exhaust cover and
bottom tray, refitting/tightening all
screws. Re-tension the belt by
closing the tension lever.
Track the belt as in previous
instructions.
Summary of Contents for BD48
Page 14: ...Charnwood BD48 Parts Drawing ...