Again, using a set square, adjust
the Worktable to 90 degrees to
the sanding belt and lock into
position.
Set the red index pointer to align
with the zero degree mark on the
angle scale.
Thread the open end of the Dust
Bag through the retaining clip and
attach to the dust port. The
tightness of the clamp can be
adjusted by turning the clamping
handle prior to locking it. Take
care not to over-tighten.
Alternatively the sander can be
connected to a suitable dust
extractor. In this case the filter
bag is removed and the extractor
hose connected directly to the
extractor port using an
appropriate adapter.
Summary of Contents for BD48
Page 14: ...Charnwood BD48 Parts Drawing ...
