Carefully remove the existing self-
adhesive sanding disc using a flat-bladed
scraper.
Remove any residue from the sanding
plate using mineral/methylated spirit.
Peel the backing from the new sanding
disc and apply to the sanding plate.
Ensure that it is positioned centrally on
the plate, then press firmly into place.
Re-fit the disc cover and tighten all
screws. Re-attach the work table.
The sanding disc can be converted to use the Hook & loop type discs.
A conversion backing pad (VB300) can be attached to the plate, then allowing Velcro-backed sanding
discs to be used. The great advantage of this system is that discs can be swapped in seconds and discs
can be remounted multiple times, allowing the user to work through different grits to achieve the desired
finish.
Replacing the Sanding Belt
Remove the back stop.
Release the tension on the sanding belt
by pulling out the tension lever.
Loosen the four screws indicated which
hold the belt lower dust cover.
Remove the screw holding the roller dust
cover using a 5mm hex key.
Summary of Contents for BD610
Page 14: ...Parts Drawing ...