It is essential to use dust extraction when
using your sander.
There is a single extraction port for the
belt and disc with an inside/outside
diameter of 45/50mm.
A 50mm diameter hose will connect
directly to the port. Our adaptor
100/58RC can be used to convert for
using 100mm diameter hose.
Setting Up
Tracking the belt
Ensure the machine is disconnected.
Slowly rotate the sanding belt by hand.
Ensure it is travelling in the direction of
the arrow.
Note if the belt is tending to slide off the
bed and to which side.
If the belt doesn’t slide sideways it is
already correctly tracked.
Viewed from the covered end
– if the belt
moves sideways towards the disc, turn
the tracking knob anti-clockwise (1/4 turn
is usually sufficient).
If the belt moves sideways away from the
disc, turn the knob clockwise.
Continue adjustments until the belt
remains central on the rollers.
Tracking knob.
Summary of Contents for BD610
Page 14: ...Parts Drawing ...