Charnwood Cove 2B, Operating & Installation Instructions Manual

The pallet is intended to be cut up and used for kindling fuel.

The Stand is first positioned on the hearth in the desired position of

the stove. The lower cover must be removed from the stove by first

unscrewing the air control knob, then removing the 6mm bolt on

each side using a 4mm allen key. The Cover may now slide off. Ensure

that the pallet brackets have been removed from the stove, then lift

the stove on to the stand, aligning the 4 tapped holes in the base

brackets with the 4 slots in the top of the stand. NOTE - This requires

at least 2 people. The stove is fixed to its stand using 4 M8 x 20mm

bolts and 4 plain washers. A 13mm open ended spanner is required.

FITTING THE STOVE TO ITS STAND

1. Centre stand

Fig. 12. Horizontal register plate with  optional vertical rear flue connector

Alternative
Soot Door
Positions

Register Plate
With Soot Door

Fig. 11. Horizontal register plate with top flue connection

Alternative
Soot Door
Positions

Register Plate
With Soot Door

1

2

2

2

3

4

4

Replace the cover, side bolts and Air Control Knob.

the stove on to the stand, aligning the 4 tapped holes in the base

brackets with the 4 slots in the top of the stand. NOTE - This requires

at least 2 people. The stove is fixed to its stand using 4 M8 x 20mm

bolts and 4 plain washers. A 13mm open ended spanner is required.

Replace the cover, side bolts and Air Control Knob.

2. Store stand

PRE LIGHTING CHECK

COMMISSIONING

Place the Store Stand on the hearth, with at least 100mm clear space

behind it. Remove the lower cover as described above - it is not used.

With 2 people, carefully lift the stove on to the stand such that the

front end of the Air Control Rod is lowered down inside the stand.

Take care not to bend or damage the Air Control Rod. Temporarily

rest the stove on the stand in this position and pull the Air Control

Rod through the hole in the front of the stand. Now move the stove

towards you to align the slots in the side of the stand with the 6mm

tapped holes in the base brackets. Fix in position with the bolts that

were used to secure the cover and replace the Air Control Knob.

Before initial lighting the following points should be checked :-

1. The bottom grate bars must all be fitted and should move freely

and easily when the riddling mechanism is operated.

2. The plates round the sides and back of the grate must be in

position and sitting correctly.

3. The throat plate must be fitted in the roof of the appliance and

should be checked to ensure that it has not become dislodged in

transit. The method of location and positioning of the throat plate is

shown in Fig. 4.

On completion of the installation and after allowing a suitable period

®

charnwood

INSTALLATION  INSTRUCTIONS

Fig. 13

13