Place the machine upright
Locate two tapped holes on the side edge
of the table
Fit the fence to the table, using the two M5
x 20mm cap head bolts and washers.
Fit the bridge guard arm pivot bolt
Screw the pivot bolt, with washer fitted,
from the inside of the table, until the full
length of the thread projects beyond the
edge of the table.
Slide the bridge guard into the end of the
bridge guard arm and secure using the
screw and washer.
Secure in place using the M6 coach bolt,
washer and plastic knob.
Summary of Contents for PT250
Page 14: ...Charnwood PT250 Parts Diagram ...
Page 15: ...Charnwood PT250 Parts List ...
