Fit the bridge guard support arm onto the
bridge arm pivot bolt.
Secure the guard by screwing the wing nut
onto the threaded bolt.
Insert the locking knob, with washer fitted,
through the curved slot in the bridge arm.
Set the bridge guard arm to the desired
angle and tighten.
The dust extraction hood has a 65mm
diameter outlet for connecting the extractor
hose.
If you are using a 100mm diameter dust
extractor hose, fit the adaptor.
PLEASE NOTE :
THE MACHINE IS
FITTED WITH AN INTERLOCKING
SAFETY SWITCH AND WILL NOT RUN
WITHOUT THE DUST EXTRACTION
HOOD CORRECTLY FITTED
The hood can be fitted in two different
ways, depending on what type of operation
is being carried out:
Planing or Thicknessing
The hood is locked in place using two
locking latches which push into a receiver.
One located on each side of the table.
Planing Operations
The dust extraction hood must be fitted
underneath the outfeed table and locked in
place using the two locking latches.
Summary of Contents for PT250
Page 14: ...Charnwood PT250 Parts Diagram ...
Page 15: ...Charnwood PT250 Parts List ...
