14
The long fence can be adjusted left
and right to suit the diameter of
tooling to be used.
The work clamp can be used to
clamp a work piece. Screw the
thread down to engage the clamp.
The flip over length stop can be
raised or lowered as shown.
Fitting a cutter block
The cutter block (not included) is
shown here assembled.
The larger of the two table inserts is
fitted into the table aperture. Always
fit the smallest table insert which the
tooling allows.
A large selection of spacers, in
varying widths are provided so that
the cutter block can be located at
the required height on the spindle.
When stacking the spacers, ensure
that the one with the roll pin is at the
top of the stack and that the pin
engages with the slot in the spindle.
(Not all of the spacers will be
required)
