6
Do the same with the rails marked ‘A’, fitting these
to the sides.
Bolt on the four legs, ensuring that they fit outside
the rails and that the narrow faces of the angles
are to the front and rear. Use the short coach
bolts, washers and nuts for this.
Bolt on the four lower rails, noting that the ends
are angled to match the splay of the legs.
Use coach bolts as before.
Place the four black rubber feet on the legs.
Bolt the two stabilisers to the back legs. These
prevent the possibility of the table tipping if a
heavy board is resting on the rear extension table.
Return the saw to a vertical position, true it up and
tighten all the nuts and bolts.
Attach the two side extension tables by pushing
the round metal tubes into the corresponding
holes in the end of the main table.
Summary of Contents for W616
Page 14: ...14 EXPLODED DIAGRAM ...
