7
The side extensions are locked in place with the
four large, black knobs which screw into the
underside of the main table.
Bolt the two blue support arms to the back of the
saw.
Loosely screw two bolts with washers into the
threaded holes in the back edge of the main table.
Loosely fit bolts, washers and nuts into the top end
of the blue support arms.
Fit the slots in the rear extension table over the
heads of the bolts.
Use a straight edge or the fence extrusion to level
the rear extension table. The surface should be
flush to the main table.
Put the push stick in its holder, on the right hand
side of the saw but please do not leave it there!
Use it whenever a cut will bring your fingers closer
than 30cm from the blade.
Summary of Contents for W616
Page 14: ...14 EXPLODED DIAGRAM ...
