10
Fit the Filter Bag
Locate the rectangle opening in the
open end of the Filter Bag.
Feed the Bag Strap into the pocket all
the way around the full circumference
of the bag, until it can be seen in the
opening again.
Engage the spring latch into one set of
hooks and fasten it with the lever.
Feed the loop sewn into the top of the
Filter Bag over the end of the Bag
Support.
Fit the 3 Way Inlet
The standard inlet on the extractor is
150mm diameter. It can be converted
to 3 x 100mm diameter inlets by fitting
the 3 Way Inlet
Use a cross head screwdriver to
remove the retaining screw from the
inlet.
Fit the 3 Way Inlet over the 150mm
inlet and then re-fit the screw.
Blanking caps are provided if only 1 or
2 x 100mm diameter hoses are to be
used.
The Extractor is now ready to be connected to the electric supply.
16 amp 240v plug 16 amp 415v plug
Installation
The extractor is supplied with wires
only.
Single phase 240v machines will have
3 wires.
3 phase 415v machines will have 4
wires.
It can be hardwired into a spur or fitted
with an industrial plug.
