Slide a 3/8 inch flat washer over the bolt
and secure with a 3/8-24 locknut.
Tighten all three bolts at the rear spring
hanger before going to the next step.
Slide the two clamping brackets over the
subframe connector. These are used to
provide a firm attachment between the
subframe boss and the subframe
connector.
Install the 1/2-20 x 3 inch bolts and
locknuts with the nut toward the outside
of the car to keep them away from
exhaust-system heat. Torque to 45 lb-ft.
Page 102
917704
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...