A set screw is used to lock the A-arm pivot
studs. The set screw locks on the groove
machined into the pivot stud.
Before installing the pivot stud set screws,
apply a drop of Loctite™ thread sealing
compound to the screws. Be careful not to
get excess Loctite™ in the pivot stud bore.
The next step is to install the upper A-arm
and spindle. During this step you are going
to need the lower A-arm at its ride height
position.
Two of these shock simulators are included
in the suspension kit. The top hole
represents full shock extension, the bottom
hole full compression, and the middle hole
(at 12 inches) represents the ride height of
the shock absorber.
917704
Page
15
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...