If additional clearance is needed between
the pinion and the cross-member, you can
raise the pinion up higher. A lower angle will
be used to clear the side motor mount
bracket. Rotate the rack to minimize the u-
joint angle.
Push the rack firmly into each mount.
Secure the rack by installing the billet rack
clamp caps. Use the provided 5/16-18 x 1”
stainless steel socket head allen and custom
lock washer. Use a small amount of
Loctite™ on the socket head allen.
Tighten the cap with your T-Handle Allen
wrench. Once you have the cap tight, the
next step will be aligning the front end.
Page 22
917704
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...