Pack the outer wheel bearing as you did the
inner one. Slide the bearing into the race.
Slide the washer over the spindle shaft and
install the castle nut.
To fully seat the bearings, tighten the castle
nut to 12 lb-ft while turning the rotor
assembly forward by hand. This will remove
any grease that could cause excessive
wheel bearing play. Back off the castle nut
to the "just loose" position and then hand
tighten. There will be .001 to .005 inches of
end play when the wheel bearings are
properly adjusted.
Page
46
917704
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...