These optional stainless steel "spuds" will
be used to fasten the billet motor mount to
the frame.
If you did not purchase the spuds, use the
stainless steel 1/2-13 x 3 1/2 inch socket
head allens and locknuts provided in the
billet motor mount kit (shown in upper left).
Insert the female spud through the frame
mount into the billet motor mount assembly
from the rear. Do the driver side first. The
passenger side frame adapter has a slot to
allow for misalignment.
Apply a small amount of Loctite™ and insert
the male portion of the spud through the
motor mount bracket and into the billet
motor mount assembly. Thread the male
and female spuds together and just finger
tighten for now.
Repeat this on the passenger side before
going to the next step.
Page
56
917704
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...