After you remove the engine, place your
vehicle on jack stands. The jack stands
must be supported by a level concrete
surface at least as large as the car. Put
two stands under the rocker panels about
4” in front of the front door. Put two stands
under the rear axle. These stand locations
will prevent the car from tilting backwards
when you remove the front clip. DO NOT
REMOVE THE FRONT SHEETMETAL.
This is a view of the passenger side inner
fender panel before we removed any
components.
Page 62
917704
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...