Drill the remaining rivet holes starting from
the top. Use the end of your 1x2 held
against the splash flap from the tire side for
a backup tool to drill the rivet holes. Make
sure the flap sits flush against the fender
panel.
Install clecos in the remaining drilled holes.
Remove the top center cleco and install the
pop rivets from the engine side of the fender
panel.
The pop rivet backup washers go against
the rubber splash flap on the tire side of the
fender panel.
Page 92
917704
Summary of Contents for 7704
Page 105: ...Page 104 917704 ...