DX-2
www.chasswheel.com
rev. 1
2014-05-08
17
described in Chapter 2.10
2.2 Using Buddy Buttons with the remote
A Buddy Button (4) is an additional button which can be used to activate remote functions. The
sockets for Buddy Buttons are located underneath the remote.
1) Socket I
(corresponds to "Activate drive mode/switch-through"
key)
The button is deactivated as standard.
2) ON/OFF socket
(corresponds to "ON/OFF" key)
3) Socket II
(corresponds to "Activate setting mode" key)
The button is deactivated as standard.
4) Buddy Button
The cover cap must be removed if sockets
1 to 3 are to be used.
To do this, remove the Phillips screw.
2.3 Steering the wheelchair with the remote
• Press the "ON/OFF" key.
• The display illuminates.
• The mode display (A) shows the drive level.
• The wheelchair is ready to drive.
• You can set the drive levels using the drive mode key
