DX-2
www.chasswheel.com
rev. 1
2014-05-08
39
is attached for the transportation (see pictures 1 and 2). Footrest should be bent down and foot
plate up. Head support is good to be adjusted in the lowest position. If necessary the head suppoert
can be removed and attach on the seat. Back rest can be bent forwards by pulling the lever on the
side of the back rest (see page 17, part “Manually adjustable back rest”). If wanted the wheelchair
can be covered for example wooden frame or cardboard box.
The wheelchair can be moved for example to truck by driving it or if the wheelchair is on the pallet,
by loading pump.
6 WHEELCHAIR SERVICING
After driving under moisture circumstances, take care of drying the wheelchair for example by
storing it in a warm space. Do not leave the wheelchair outside or in cold and moisture spaces. Not
following these instructions might damage the wheelchair.
By servicing the wheelchair regularly, you ensure the functioning and safety of your wheelchair. A
well serviced wheelchair is a long-term aid and it can last at least ten years if service is taken care
of. Part of the servicing can be performed by users themselves (these operations are mentioned
below). However, the more demanding service operations (such as electrical malfunctions, driving
motors, actuators, frame parts, seat parts, foot and arm rests, changing the tyres and other
technical problems) can only be done by a qualified technician in order to maintain the warranty.
The manufacturer intends the wheelchair to be serviced/maintenanced by qualified technician (either
distributor, service agent or the manufacturer) at least once a year.
Service card of the wheelchair is in the last pages of the Owner’s manual. Please take care of that
the Owner’s manual goes with the wheelchair to the service. When it is a time to service the
wheelchair, please contact to your FOUR X distributor.
Following routine operations the manufacturer intends the user to be responsible:
-
daily inspections
-
weekly inspections
-
cleaning the wheelchair
If necessary the user could ask assistant or some other person for help.
6.1 Daily inspections
Before beginning the drive check the general condition of the wheelchair visually. When the driving
controller is switched off, check that the joystick is not bent or damaged and that it returns to the
middle when released. Check that all the connectors are in place and undamaged and the cables are
in good condition. Check that the thin protective rubber around the steering stick is not damaged.
Handle the protective rubber with care. Make sure that the control module is well attached to the
wheel chair. Do not over tighten the screws.
6.2 Weekly inspections
