www.chasswheel.com
48
2.
Move the foot-rest up. Open the bolts, (4
pcs.) and remove the plastic cover. Open the
seat nuts, (4 pcs.) and remove the seat.
1.
Remove the cover fabric in the back of the
seat frame. Cables 2 and 3 are attached into
the cable 1, which is connected to the Power
Module. Detach the lights’ white connectors.
MEASUREMENT OF TYRE’S AIR PRESSURE
The appropriate tire’s air pressure is approximately
3.5 bar. It should be avoided for the air pressure to
fall below 1.3 bar or increase over 3.5 bar. This will
cause the wearing of the tires, reduces the hold of
the tires and causes excessive friction which will
decrease the carried out distance.
CHANGING OF A WHEEL
Wheel is connected with four hex screws, the size of the key is 4 mm. Open the screws and remove
the wheel. The sides of the wheel are attached with smaller screws which cannot be opened before
the air pressure has been released from the tire do not attempt to open the center bolt as this holds
the hub to the axle.
DISASSEMBLING OF THE SEAT AND BATTERIES
Disconnect the following cables of the batteries: (- and +) (A and B) and main circuit breaker (C), by
using an 11 mm spanner. Take the batteries out of the casing by using the belts around the
batteries.
