www.chasswheel.com
50
PROGRAMMING
Wheelchair’s driving settings can be changed through programming. When the wheelchair is handed
over to a user, its settings have been set so that they are suitable for most users. Through
programming can be changed e.g. the reaction time of the steering lever, the transitional time of the
electric flow going into save mode and the speed of the turning wheels. If you want to change the
wheelchair’s settings, then contact either the wheelchair’s supplier or manufacturer.
CHANGING THE LIGHT BULBS
The wheelchair’s light bulbs are maintenance-free. In case of a possible problem, the whole light has
to be changed.
Open screws located behind the lamp
(In rear lights screws for rubber fasteners are
located below the covering.
In front lights screws are located on top of the
covering.)
DRIVING LAMP: Maintenance-free LED-lamp
REAR LAMP: Maintenance-free LED-lamp
DIRECTION-INDICATOR LAMP: Maintenance-
free LED-lamp
ELECTRICAL DISTURBANCES IN THE WHEELCHAIR’S WORK
If the steering device notices a disturbance in the electric system, then a tool symbol starts flashing
For securing safety, the usage of the wheelchair during the disturbance is prevented. The most
common electric system disturbances are derived from interfaces or batteries. The reasons of the
most often occurring disturbances are described below.
Steering device has gone into an electric power saving mode. It happens automatically when the
steering device has not been used for a while. Time depends on the setting of the steering device.
For switching it on, the steering device needs to be switched off for once and then switched on
again.
The batteries have not been charged correctly if the symbol of the batteries’ charge starts flashing.
Batteries need to be charged on the first opportunity.
When charging batteries, check that the charging interface is not connected to the steering device.
