Connecting (Cabling) Each PVP™
16-
PVP™ Series User Manual, Rev. 4
Connecting Power
and Signal Cables
The following sections provide information and diagrams on connecting signal and power
between panels.
Refer to the
sections in this User Manual for available cables
and item numbers.
Connecting
the Signal Between
Joined Panels
Signal cable panel connections can use several different configurations. The basic
configuration to connect the signal from one panel to the next is as follows.
•
The source signal is connected to the first panel.
•
A signal cable is then connected from the first panel.
•
The connections continue to daisy-chain until all panels are connected.
•
The route of the cables used to make the signal connections can vary.
The following diagrams are recommended suggestions for signal connections between
24 or less panels, and more than 24 panels.
Refer to
for information and instructions on connecting the
signal from the source.
This diagram shows an example of a simple signal connection using 24 or less PVP™s.
VIP™ Driver
DVI-D
Video Signal Cable
in from VIP™ Driver
max. cable length
100 m/328 ft
Signal Jumper Cable
May be used to run
a backup line to the
VIP™ Driver
Summary of Contents for PVP S5
Page 1: ...User Manual Series ...
Page 112: ...Contact Us ...
