Setup
PVP™ Series User Manual, Rev. 4
7
3. Setup
AC Power
Each PVP™ has an auto-ranging power supply that works with an input voltage range of
100–240 VAC, 50/60 Hz. To determine the power requirements for each PVP™ in the
series, refer to the label affixed to the product. You can also refer to the
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
Each PVP™ comes with a power linking cord to connect power between panels;
however, the power input cord is only included with the 8-pack flight case.
This cable has a powerCON® connector to connect to the PVP™ and an Edison plug for
power input. Use the table below as a reference to wire a new plug.
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Power Linking
All panels in the PVP™ Series support power linking. Refer to the following table for
specifications on each panel.
PVP™ S5
PVP™ S7
@ 120 V, 60 Hz
9
16
@ 208 V, 60 Hz
16
27
@ 230 V, 50 Hz
18
28
Please refer to all applicable local codes and regulations for the proper installation
of this product.
Summary of Contents for PVP S5
Page 1: ...User Manual Series ...
Page 112: ...Contact Us ...
