EN
2
Rogue Outcast 3 Spot QRG Rev. 1
QUICK REFERENCE GUIDE
What is Included
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
It is possible to link up to 2 Rogue Outcast 3 Spot products at 100 V, 3 products at 120 V, 5 products at 208 V, 6 products
at 230 V, or 6 products at 240 V. Never exceed this number. Power linking cords can be purchased separately.
AC Plug
Replacing the Fuse
1. Disconnect the product from power.
2. Using a flat head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
DMX Linking
The Rogue Outcast 3 Spot will work with a DMX controller using a 5-pin DMX serial connection. A DMX Primer is
.
DMX Connection
The Rogue Outcast 3 Spot uses a 5-pin DMX data connection for its DMX personalities:
20CH
and
25CH
. See the User
Manual for information about connecting and configuring the product for DMX operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller’s User Manual or with the manufacturer as not all DMX controllers
have this capability. The Rogue Outcast 3 Spot supports RDM protocol that allows feedback to make changes to menu
map options. Download the User Manual from
for more details.
•
Rogue Outcast 3 Spot
•
Seetronic Powerkon IP65 power cord
•
2 omega brackets with mounting hardware
•
Quick Reference Guide
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow/Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
!
