Page 4 of 14
4BAR™ User Manual (Rev. 6)
Product at a
Glance
Use on Dimmer
x
Auto Programs
P
Outdoor Use
x
Auto-ranging Power Supply
P
Sound Activated
P
Replaceable Fuse
P
DMX
P
User Serviceable
x
Master/Slave
P
Duty Cycle
x
Safety Notes
These notes include important information about mounting, usage, and maintenance;
read before using the product.
•
Always connect the product to a grounded circuit to avoid the risk of electrocution.
•
Always disconnect the product from the power source before cleaning or replacing
the fuse.
•
Avoid direct eye exposure to the light source while the product is on.
•
Make sure the power cord is not crimped or damaged.
•
Never disconnect the product from power by pulling or tugging on the cord.
•
If mounting the product overhead, always secure to a fastening device using a
safety cable.
•
Make sure there are no flammable materials close to the product when operating.
•
Do not touch the product’s housing when operating because it may be very hot.
•
Always make sure that the voltage of the outlet to which you are connecting the
product is within the range stated on the decal or rear panel of the product.
•
The product is for indoor use only! (IP20) To prevent risk of fire or shock, do not
expose the product to rain or moisture.
•
Always install the product in a location with adequate ventilation, at least 20 in
(50 cm) from adjacent surfaces.
•
Be sure that no ventilation slots on the product’s housing are blocked.
•
Never connect the product to a dimmer.
•
Make sure to replace the fuse with another of the same type and rating.
•
Never carry the product from the power cord or any moving part. Always carry by
the bar or carrying case.
•
The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate the
product at higher temperatures.
•
In the event of a serious operating problem, stop using the product immediately.
•
Never try to repair the product. Repairs carried out by unskilled people can lead to
damage or malfunction. Contact the nearest authorized technical assistance center.
•
This product is not intended for permanent installation.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
•
Keep this User Manual for future use. If you sell the product to another user, be
sure to give this document to the next owner.
Summary of Contents for 4 Bar Flex
Page 1: ...User Manual ...
