O
PERATION
COLORdash Par-H12 IP User Manual Rev. 1
Configuration (DMX)
Use DMX configurations to operate the product with a DMX controller.
DMX Personalities
This setting allows you to choose a particular DMX personality.
1.
Go to the
DMX Channel
main level.
2.
Select the desired personality (
6 Ch
,
8 Ch
, or
13Ch
).
DMX Control
In this mode, each product will respond to a unique starting address from the DMX controller. All products
with the same starting address will respond in unison.
1.
Select a DMX personality as shown in
2.
Set the starting address:
a.
Go to
DMX Address
main level.
b.
Select the starting address (
001
–
512
).
The highest recommended starting address for each DMX mode is as follows:
LED
Frequency
600Hz
Selects the PWM output frequency
1200Hz
2000Hz
4000Hz
6000Hz
25kHz
Back Light
On
Display backlight always on
10S
Turns off display backlight after 10 sec of
inactivity
20S
Turns off display backlight after 20 sec of
inactivity
30S
Turns off display backlight after 30 sec of
inactivity
Key Lock
On
Turns the passcode on or off
Off
Information
Fixture Hours
Shows total product hours
Version
Shows installed software version
UID
Shows product UID
Battery
Shows battery level
Reset
Factory
No
Reset all settings to factory defaults
Yes
•
See the
section for the highest starting address you can select for
each personality.
•
Make sure that the starting addresses on the various products do not overlap due
to the new personality setting.
DMX Personality
DMX Address
13
500
8
505
6
507
Main Level
Programming Levels
Description
Summary of Contents for COLORdash Par-h12 ip
Page 1: ...User Manual...
