Page 14 of 22
EZwedge™ Tri User Manual Rev. 1
DMX
Configuration
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket on the
product.
DMX
Personalities
and Starting
Address
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If you choose a starting address that is too high, you could restrict the access to some of the
product’s channels.
The EZwedge™ Tri uses up to 8 DMX channels in its 8-channel DMX mode, which defines the highest
configurable address to
505
.
If unfamiliar with DMX, download the DMX Primer from
To select the DMX personality and starting address, do the following:
1. Press
<MENU>
repeatedly until
3-CH
(3-channel mode) or
8-CH
(8-channel mode) shows on the
display.
2. Press
<ENTER>
and
d 1
–
d512
shows on the display.
3. Use
<UP>
or
<DOWN>
to select the starting address.
4.
Press
<ENTER>
.
After the DMX starting address and personality have been set, there will be a delay of 30
seconds before the display automatically returns to showing the current DMX address
and the DMX personality.
Summary of Contents for EZ WEDGE Tri
Page 1: ...User Manual ...
