Chauvet MiN Wash, User Manual

Operation 

Stand-Alone Mode (Auto Mode): 

This mode allows a single unit to run to a factory installed program in one of two speeds. 

1)  To set the fixture in auto mode 

Fast

, select                 .  Once confirmed the display reads       

2)  To set the fixture in auto mode 

Slow

, select                    Once confirmed the display reads 

Master/Slave Mode (Master Sound): 

This mode will allow you to link up to 32 units together without a controller. 

1)  Use standard DMX cables to daisy chain your units together via the DMX connector on the rear 

of the units. Proper performance it may be necessary to use a terminator at the last fixture. For 
more information about terminators, see page 8. 

2)  Choose a unit to function as the Master. Select NAFA/NASL or NStS (see below for readout) 

depending upon which master mode you require. The master unit must be the first unit in line. 
Finally, chain the units together using DMX cable. 

Master Auto   

                 or                       

 
Master Sound   

becomes   

     when confirmed 

3)  Select slave function by using the Up/Down keys to reach SLAv in the Master/Auto menu on the 

slave units, and they will react in the same as the Master. 

Slave 

   becomes  

when confirmed 

DMX Mode 

This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with 
DMX, please read the DMX Primer on page #19.  

1) The default mode for the fixture is DMX, which appears as                  on the LED Readout. 

MinWash 13 

2007-09-14/09:44