18
Operation
Net-X II User Manual Rev. 3
Scene Name
The Net-X II allows you to customize the name of each scene. To name a scene, do the following:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select
1. Name:Scene_1–10
.
3.
Press the knob.
4.
Use the knob to select the letter, number or symbol, from
A–@
. There are 96 options.
5.
Repeat until the name is set as desired.
6.
Use the knob to select either
Enter
to save the name, or
Cancel
to exit without saving.
7.
Press the knob.
Scene Steps
This feature displays the amount of steps saved to the scene. To view previously saved steps, follow the
instructions below:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select
2. Step:(0/0)
.
3.
Press the knob.
4.
Turn the knob to cycle through the saved steps.
Add Step
This function adds a step to the scene. To add a step to the scene, do the following:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select
Add Step
.
3.
Press the knob.
Delete Step
This function deletes a step from the scene. To delete a step from the scene, follow the instructions below:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select
Delete Step
.
3.
Press the knob.
Timing
This function sets the intervals between steps, as well as a fading effect if desired.
1.
Select the Scene to configure as instructed in
2.
Use the knob to select
5. Timing.
3.
Press the knob.
4.
Use the knob to select:
•
2.
Fade In Time:0.10S—9M59S.
•
Press the knob.
•
3.
Fade Out Time:0.10S—9M59S.
•
Press the knob.
•
4.
Delay Time:0.10—9M59S.
•
Press the knob.
•
5. Exit
(to cancel).
5.
Select
1. Save Step
menu option to save timing settings.
Trigger Settings
The Net-X II can assign a trigger to an external dry contact switch to trigger a recorded scene. When the
trigger is turned on, the Trigger Info will display on the display screen with the scene name, amount of
steps, and the timing set for that scene.
1.
Use the knob to select
11. Trigger Settings
.
2.
Press the knob.
3.
Use the knob to select
Trigger 1–4
.
4.
Press the knob.
5.
Use the knob to select the desired
Scene 1–10
.
6.
Press the knob.
Summary of Contents for NET-XII
Page 1: ...User Manual Version V1 6 ...
