Rev. 9
16
Stage Designer™ 50
Delete a Step or Steps
Action
·
1.
Enter the
EDIT
enable.
2.
Tap the
Step
button to scroll to the step you
wish to delete.
3.
Tap the
Delete
button when you reach the
step you wish to delete. All LEDs will light,
indicating the deletion of the step.
4.
Repeat steps 2 and 3 until all of the
unwanted steps have been deleted.
5.
Press and hold the
Record
&
Rec Exit
button. The
Scene
button LED will turn off,
indicating that the Edit mode has been
exited.
Notes
¥
Insert a Step or Steps
Action
·
1.
Record a scene or scenes you wish to
insert.
2.
Be sure you are in
Chase◄►Scene
and
enter the
Edit enable.
3.
Tap the
Step
button to scroll to the step
which you wish to insert the step before.
You may read the step from the display.
4.
Tap the
Insert
button to insert the step
you’ve created before.
6.
Exit
Edit enable.
Notes
¥
Part of entering the Edit enable is selecting
which scene you wish to Edit. See section on
Edit enable for further instructions.
All LEDs will flash to indicate a successful Insert
of the step.
Modify a Step or Steps
Action
·
1.
Edit enable.
2.
Press and hold the
Up
button if you want to
raise the intensity. Press the
Down
button if
you want to lower the intensity.
3.
Tap the
Step
button to scroll to the step
which you wish to insert the step before.
You may read the step from the display.
4.
While holding the
Up
or
Down
button, tap
the
Flash
button corresponding to the DMX
channel of the
Scene
you wish to modify
until you reach the desired intensity value
read from the display. Then, you may tap
the
Flash
buttons until you are satisfied with
the new
Scene
.
5.
Repeat steps 2, 3, and 4 until all the steps
have been modified.
6.
Exit
EDIT
enable.
Notes
¥
Part of entering the Edit enable is selecting
which scene you wish to Edit. See section on
Edit enable for further instructions.
All LEDs will flash to indicate a successful Insert
of the step.
Summary of Contents for Stage Designer 50
Page 1: ...User Manual ...
