Stage Designer™ 50
17
Rev. 9
5.
P
LAYBACK
This controller uses the Channel Faders and Channel Flash buttons for multiple uses. In this occurrence,
Channel Faders 13-24 (37-48) are used for the playing back of Scenes already recorded. This is only when the
controller is in the
Chase◄►Scene
mode. In this instance,
Master Fader A
will control the manual fader
controls, while
Master Fader B
will control the Scenes being played back.
Playing a Scene
A Scene can contain up to 1,000 steps. The term steps and scenes are used interchangeably in this manual.
Action
·
1.
Tap the Mode Select button to select
Chase◄►Scene
mode
.
2.
Tap the
Page
button to select the
correct page the program you wish to
run is located.
3.
Push master Slider B to its maximum
position (fully down).
4.
Move the desired
Channel
slider (13-
24) to its maximum, and the
Scene
will
fade in depending upon current fade
time.
5.
Move the channel slider to adjust the
output of the current program.
Notes
¥
The current mode is indicated by the 3 LEDs.
Red is the
Chase◄►Scene. Yellow is 2-scene
preset A/B. And, Green is 1-24 single mode.
You may press and hold down the relevant
Flash button for the Scene to trigger the button
momentarily.
Playing a Scene with Audio Triggering
Action
·
1.
Select your
Scene
as described in the
above section.
2.
Tap the
Audio
button until its LED
lights, indicating
AUDIO
mode is
active.
3.
Use the
Audio Level
slider to adjust
the sensitivity.
4.
To return to normal mode, tap the
Audio
button a second time, causing
its LED to go out.
AUDIO
mode is
disengaged.
Notes
¥
This is the process of using the built-in
microphone, or using the audio jack located on
the rear of the controller to use an alternative
audio source for triggering of the Scenes.
Playing a Scene with the Speed Slider
Action
·
1.
Select your Scene as described in the
above sections.
2.
Move the Speed slider to SHOW
MODE position (fully down).
3.
Press and hold the Rec Speed button
& tap the corresponding Flash button
(13-24). The Scene tapped will no
longer run with the standard beat.
4.
Now, you may move the Speed slider
to select your desired speed.
Notes
¥
Be sure AUDIO mode is disengaged.
Step #3 is not necessary if the selected Scene is
not recorded with the Standard beat.
Summary of Contents for Stage Designer 50
Page 1: ...User Manual ...
