Rev. 9
18
Stage Designer™ 50
Playing a Scene with the Standard Beat
Action
·
1.
Tap the Mode select button to select
Chase◄►Scene mode.
2.
Tap the Park button to select Mix
Chase mode. The LED lights,
indicating the selection.
3.
Select your Scene as described in the
previous sections.
4.
Move the Speed slider until the display
reads your desired value.
5.
Press and hold Rec Speed button &
tap the Flash button (13-24) to store
the Scene. The Scene will now run
with the set time or beat when
engaged.
6.
Repeat steps 4 & 5 to set a new beat
time.
Notes
¥
Be sure AUDIO mode is disengaged.
As an alternative to using the Speed slider to
input the speed, you may use the Tapsync
button (2) times to define your beat.
Change the Speed Mode Between 5 & 10 Minutes
Action
·
1.
Press and hold the Record button.
2.
Tap the Flash button 5 or 10 three
times while holding down the Record
button.
3.
The 5min or 10min LED should light,
indicating the Speed the slider is set to
run.
Notes
¥
Auxiliary Controls
This is the process of assigning the Auxiliary controls. These will act as shortcuts and are most commonly used
for DMX strobe lights or DMX fog machines. However, they are not limited to these functions, such as Pan/tilt
control-very useful for remote followspot controls.
Action
·
1.
Press & hold RECORD & tap the Flash
button 7 or 8 (3) times. The display should
indicate activation of the mode.
2.
There are 3 functions.
FUNC 1
states that
the Auxiliary control is not assigned to any
channel.
FUNC 2
refers o the auxiliary
controls working much like the channel
fader along with the flash buttons.
FUNC 3
is somewhat different. The rotary knob acts
to set the total output of the flash button
below it.
3.
While holding down the
RECORD
button,
select the function you wish for the auxiliary
control by pressing
Flash
button 1, 2, or 3.
Release the buttons.
4.
To assign the auxiliary to a channel, press
the
Flash
button for the channel you wish to
assign the auxiliary control to. This sets the
channel assignment. The corresponding
Led above the channel will light, indicating
that the channel has ben assigned.
5.
Record exit.
Notes
¥
You may refer to the display for the functions being
edited.
Press 7 (3) times for AUX 1 patching, and 8 (3) times for
AUX 2 patching.
While assigning an auxiliary to mode 2, the Fader for that
channel will not function. It will act as moving the
channel.
While assigning an auxiliary to mode 3, the channel fader
and the auxiliary controls will both work for that channel
on an HTP (highest takes precedent) operating principle.
Summary of Contents for Stage Designer 50
Page 1: ...User Manual ...
