TFX-950CM User Manual
6
Revision: 2006-01-20/16:37
TFX-950CM Lamp Installation
Lamps exposed
Remove these 2 screws
Slide switch up or down
depending on your line voltage.
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. Three EHM 300W halogen
lamps are included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST AL L AT I O N
1)
Remove the 2 screws as illustrated in Figure 3,
located on the front of the fixture and lift the entire
cover plate until lamp reflectors are exposed.
2)
The linear lamp is held in place by tension provided by
springs inside of both ceramic socket ends. It is
important to proceed with lamp removal and
replacement very delicately.
3)
Hold linear lamp with a napkin and push in the
direction of either of the two ends to relieve tension on
the opposite end. Then pull end of lamp upwards to
remove from socket.
4)
To replace lamp, follow the same procedure as above
to insert lamp into the socket.
5)
Lower the cover plate and replace both screws.
6)
No lamp alignment is necessary for this fixture.
Power
Your product is equipped with switch-selectable AC power
setting.
Warning!
Verify that the power select switch on your unit
matches the line voltage applied. All fixtures must
be connected to circuits with a suitable Earth
Ground.
To determine the power requirements for a particular fixture,
see the label affixed to the back plate of the fixture or refer to
the fixture
’
s specifications chart.
A fixture
’
s listed current rating is its average current draw under normal conditions.
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100%
switch.
Before applying power to a fixture, check that the source voltage matches the fixture
’
s requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.
