Operation
-16-
WELL™ Quad-M User Manual
Dimmer Curves
This setting provides you with four options to simulate the dimming curve of an
incandescent light product.
1. Go to the
SET
main level.
2. Select
DIMX
.
3. Select the desired dimmer curve (
OFF
,
DIM1
,
DIM2
,
DIM3
, or
DIM4
).
OFF
The output is proportional (linear) to the dimmer and RGBA channel
values.
DIM1~4:
The output follows the dimmer and RGBA channel values based on the
corresponding dimmer curve, being
DIM1
the fastest and
DIM4
the
slowest.
Dimmer Curve
Settings
This setting allows you to select the dimmer curve shape using the red, green, blue,
amber, and dimmer faders.
1. Go to the
SET
main level.
2. Select
CURV
.
3. Select the desired dimmer curve (
OFF
,
CV1
,
CV2
, or
CV3
).
OFF
This output is proportional (linear) to the Dimmer and RGBA channel
values.
CV1~3
This output follows the dimmer and RGBA channel values based on the
corresponding dimmer curve, being
CV1
the fastest and
CV3
the slowest.
For optimum control of the 16-bit dimming channels in the TR16 personality, be
sure that both dimming curves in SET > DIMX and SET > CURV are set to OFF
Control Panel Lock
This setting enables you to activate or disable the control panel lock, which keeps non-
authorized personnel from changing the product’s settings.
1. Go to the
KEY
main level.
2. Select
ON
or
OFF
.
When the control panel lock is active, the product will prompt you to enter the
password after 30 seconds of control panel inactivity or after turning on the
product.
Password
If you are prompted to enter a password on the product, press the buttons in the
following order:
UP > DOWN > UP > DOWN > ENTER
. The product’s password cannot
be changed and must be entered whenever you are prompted.
Settings Lock Out
This setting enables you to activate or disable the main level
SET
(settings) lock, which
keeps unauthorized personnel from changing the product’s settings.
1. Go to the
SET
main level.
2. Select
SLCK
.
3. Select
ON
or
OFF
.
