Before You Begin
2
Xeno™ 2500 User Manual Rev. 1
Product at a Glance
Use on Dimmer
Auto Programs
Outdoor Use
Auto-Ranging Power
Supply
Sound Activated
Replaceable Fuse
DMX
User Serviceable
Master/Slave
Duty Cycle
Safety Notes
Please read the following Safety Notes carefully before starting to work with the product.
These notes provide important safety information about the installation, usage, and
maintenance.
DO NOT change lamp while product is plugged into power! Serious personal
injury can occur. See
Lamp Replacement
in the Setup section for the proper
procedure to change the lamp.
This product contains no user-serviceable parts. Any reference to servicing in this
User Manual will only apply to properly trained CHAUVET® certified technicians.
Do not open the housing or attempt any repairs.
Please refer to all applicable local codes and regulations for the proper installation
of the product.
Personal Safety
•
Avoid direct eye exposure to the light source while the product is on.
•
Always disconnect this product from its power source before servicing.
•
Always connect this product to a grounded circuit to avoid the risk of electrocution.
•
Do not touch this product’s housing during operation because it may be very hot.
Mounting and Rigging
•
This product is for indoor use only! To prevent risk of fire or shock, do not expose this
product to rain or moisture.
•
Make sure there are no flammable materials close to this product while it is operating.
•
When hanging this product, always secure to a fastening device using a safety cable.
Power and Wiring
•
Always make sure you are connecting this product to the proper voltage in
accordance with the specifications in this manual or on the product’s specification
label.
•
Never connect this product to a dimmer pack or rheostat.
•
Never disconnect this product by pulling or tugging on the power cable.
Operation
•
Do not operate this product if you see damage on the housing, lenses, or cables.
Have the damaged parts replaced by an authorized technician at once.
•
Do not cover the ventilation slots when operating to avoid internal overheating.
•
The maximum ambient temperature is 104° F (40° C). Do not operate this product at
a higher temperature.
•
In case of a serious operating problem, stop using this product immediately!
•
CAUTION
: Flashing light is known to trigger epileptic seizures. User must comply
with local laws regarding notification of strobe use.
In the unlikely event that your CHAUVET® product may require service, contact
CHAUVET® Technical Support.
