8
8
2.4 The stand
There are two stand positions, one for suspending the multimeter (position 1) and the other providing a stand (position 2). To
change the stand position, proceed as follows:
Position 1: fit the stand studs into the upper holes located on
the rear of the unit:
Position 2: fit the stand studs into the lower holes located on
the rear of the unit:
3. FUNCTIONS
3.1 Switch functions
To access the
,
,
,
,
,
, or
function, turn the switch to the selected function
position. Every position (except OFF) is confirmed by a beep.
When the quantity V or A is selected, the multimeter is in AUTO AC/DC. It then determines whether the measurement is an
AC or DC measurement. The larger component is the one displayed. You can deactivate this automatic function and force
AC or DC coupling by pressing the
key. To reactivate the function, you must turn the switch and then set it to V or A
again, depending on the case.
3.1.1 Types of measurements
Below are the possible combinations depending on the type of measurement:
Types of measurements
Max / Min
Auto/ Range
LowZ AC,
AC,
AC
9
-
9
DC,
DC
9
9
9
9
9
9
9
9
9
9
-
9
