7
7
1.4. The terminals
These are the multimeter terminals:
Figure 4: the terminals
The terminals can be used to carry out the measurements using test-probe leads shipped with the instrument. The
connection principles are described in paragraph 3.
2. USE
2.1 First use
Fit the battery shipped with the instrument as follows:
1. Using a screw driver, unscrew the four screws on the cover (item 1)
located at the rear of the unit;
2. Place the battery in its housing (item 2) while respecting the polarity;
3. Screw the cover back on.
Figure
5:
access
to
the
battery
2.2 Starting up the multimeter
The switch is in the OFF position. Turn the switch to the function of your choice. All the display segments appear for a few
seconds, then the screen for the selected function is displayed. The multimeter is now ready for measurements.
2.3 Turning off the multimeter
The multimeter can be turned off either manually by returning the switch to the OFF position, or automatically after ten
minutes without use. After nine minutes an intermittent sound alarm is triggered until the instrument is shut down. Once the
instrument is shut down, to reactivate it press the
key or turn the switch by at least one position. The latter method
cancels the active functions.
2.4 The stand
There are two stand positions, one for suspending the multimeter (position 1) and the other providing a stand (position 2). To
change the stand position, proceed as follows:
Position 1: fit the stand studs into the upper holes located on
the rear of the unit:
Position 2: fit the stand studs into the lower holes located on
the rear of the unit:
1
N°. Input
1
6 A, 10 A current
2
20 µA, 6000 µA, 60 mA, 600 mA current
3
Other measurements
4
Common
1
2
3
4
2
